Grading Policy
There are two components to your raw total:
- Homeworks: 25%
- Remember we have a drop policy so if you miss a homework due to illness or did not perform as well as you’d hoped, you have an opportunity to bounce back.
- Specifically, we will include only the top 27 homework problems (including the lab problems) scores in computing your final grade. We expect to grade 9 homeworks, each with 4 problems. Should for some reason we would grade less homework problems, we will still use the top 27 homework problems.
- If you submit everything, this policy is equivalent to dropping 9 homework problems.
- If you submit less than 20 homework problems you are likely to fail unless there is an overriding excuse.
- Exams: 75%
- There will be three midterm exams, and a cumulative final exam.
- We will drop the lowest exam grade (including the final). Hence, each exam is worth 25% but if you screw one up, never fear, one exam will get dropped. Alternatively, if you do well on the midterms and want to skip the final, go for it! We will try our best to give students a projected final grade after the third midterm.
- Keep in mind that regardless of the exam you drop, you will still be tested on the entire course content since the final is cumulative.
- I will use a flat curve to make all the exam averages to be approximately 70 points. Thus it should be beneficial to drop one exam over another.
- There will be no conflicts. The drop policy is specifically for individuals that need a bit of a break for whatever reason (illness, duty, etc.).
- I don’t want to be the arbiter of what is and isn’t a valid reason to miss your work (and neither should students have to plead and hope for mercy from professors). That is why I constructed this policy that is merciful but will apply it strictly. If you have a serious issue that cause you to miss two or more midterms, you need to contact your department’s advising office and/or the emergency dean.
- I firmly believe that an exam grade distribution with a mean of 50 is best because it allows me to maximize the standard deviation on both ends. This is important to me since tests with a large uniform distribution allow test takers to make a few mistakes without it altering their final grade too much.
- The above being said, I have made an effort to increase the average of my exams to ~70 to be more in-line with typical American standards. I’m doing this simply because there is a minority of students that vehemently believe all tests should have an average of at least 70 and don’t even pay attention to standard deviation. They are wrong, and in the past two semesters where the exam averages were higher, final grade cutoffs were significantly smaller which meant a lot of people missed a letter grade because of a missed exam problem. That sucks. But this minority of students that committed to this idea of high averages is aggressively vocal (especially online) and those that understand the policy and its benefits don’t speak up. I’m not here to be a martyr so if you do agree with me about the larger distribution, please speak up. Email the department admins, contact your student organizations, etc. But I have fought long and hard to change this course for (in my opinion) the better and have been thoroughly shut down. I can’t do it anymore.
Final grade calculation
There are two grade distributions that I use when calculating a final grade. The first is a deterministic grade distribution which is the standard cutoffs used in most American educational systems:
A+ |
A |
A- |
B+ |
B |
B- |
C+ |
C |
C- |
D+ |
D |
D- |
F |
97+ |
96-93 |
92-90 |
89-87 |
86-83 |
82-80 |
79-77 |
76-73 |
72-70 |
69-67 |
66-63 |
62-60 |
59-0 |
These are the minimum grades that you can achieve in this course using the raw final grade (which includes the flat curve for each exam). Now here is the thing, no one use the standard cutoff calculation. All professors grade relatively. Yes, even the ones that say they don’t. Those professors that say they have a firm, preset grading cutoff are usually older and have banks of questions that they have tested over the course of decades, so they know the performance distribution of any particular question ahead of time.
I can’t do this since I try to constantly find and develop new problems and hence, I’m never really sure how hard the students will find these new problems. So while I won’t give anyone a grade less than the distribution above dictates, I will use an additional relative grading scheme layer where the cutoffs are determined such that the percentage of students getting each letter grades is approximately:
A's |
B's |
C's |
D's and F's |
30% |
35% |
25% |
10% |
This typically puts the average GPA of my course right around ~3.2 ish which is mostly in-line with what I see in the rest of the ECE department. I’m not promising an exact average, could be a bit lower, could be higher, but that’s the rough target.
Important notes:
- Grade cutoffs change for every semester simply because the exam/homework garde distributions change every semester.
- Cutoffs (even for the relative scheme) are finalized after the third midterm so students can figure out if they want to take the final or not.
Regrade requests
All regrade requests would be handled via Gradescope. Regrade requests can be submitted at most a week after the grades are posted on Gradescope.
Extra credit (which is given completely in the discretion of the instructors) would be given in exceptional cases for the following:
- Being in the top few participants on piazza. (As long as most of your answers are useful and correct [and add to the current discussion {i.e., don’t repost others answers just to increase your count}] - a campaign of disinformation on piazza would gain you little.)
- Taking on small, interesting problem/research challenges I may post to the website.
- Extra credit is only given to people that have completed significantly more work than is required for this course. Significant means tens of hours of solid work/effort.